Zanussi ZWF 91483WH User Manual page 11

B
When you use the liquid detergent:
• Do not use gelatinous or thick
liquid detergents.
• Do not put more liquid then 120
ml.
• Do not set the delay start.
A
• Measure out the detergent and the fabric
conditioner.
• Put the detergent and the fabric conditioner
into the compartments.
• Carefully close the detergent drawer.
Activating the appliance
Press and hold for a couple of seconds the
button to activate or deactivate the appliance.
A tune sounds when the appliance is activated.
The appliance performs a start up animation.
The animation quickly shows each washing
programme and the default temperature and
spin settings.
The display shows the word On.
Setting a programme
1. Touch the programme button
programme:
• The indicator of the button
• The display shows the programme
duration.
2. If necessary, change the temperature and
the spin speed or add available options.
When you activate an option, the indicator
of the set option comes on.
www.zanussi.com
2. Adjust the flap in
position B.
3. Put back the drawer in
the recess.
When the flap is in
position B and you want
to use powder detergent:
1. Remove the drawer.
2. Adjust the flap in
position A.
3. Put back the drawer
in the recess.
and set the
flashes.
If you set something incorrect, the
display shows the message
Starting a programme without the
Finish In option
Touch the button
• The indicator of the button
flash and stays on.
• The programme starts, the door locks,
the indicator
• The drain pump can operate for a short
time at the beginning of the washing
cycle.
After approximately 15 minutes from
the start of the programme:
• The appliance adjusts
automatically the programme
duration agree with the laundry
load.
• The display shows the new value.
Starting a programme with the Finish In
option
1. Touch the button
choose the number of hours in which you
want the washing cycle to be finished.
The display shows the number of hours you set
(e.g. ) and the indicator above the button
is on to show that his option is active.
2. Touch the button
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the Finish In option before you touch
the button
button you can only cancel the
Finish In option.
To cancel the the Finish In option:
a. Touch the button
appliance to pause. The indicator of
button flashes.
b. Touch the button
above this button goes off.
Touch the button
programme immediately.
.
.
stops to
is on.
again and again to
:
. After touching the
to set the
until the indicator
again to start the
11