Panasonic Diga Blu-ray DMR-BCT950 Operating Instructions Manual page 94

Convenient functions
Basic Settings
7.1ch Audio Reformatting
[BD-V]
Surround sound with 6.1 ch or less is
automatically expanded and played back at
7.1 ch.
• If "Off" is selected, sound is played over the
original number of channels. (Note that in
the case of 6.1 ch audio, playback will be at
5.1 ch)
Audio reformatting is enabled in the following
cases:
- When you have selected "PCM" in "Digital
Audio Output". (
- When the audio is Dolby Digital, Dolby
Digital Plus, Dolby TrueHD or LPCM.
Contents Type Flag
If "Automatic" is selected, the optimal method
of playback depending on the TV (e.g.
cinema) will automatically be selected (only
when the TV supports Contents Type Flag).
VIERA Link
Select "Off" when you do not want to use
VIERA Link.
Common Interface
Access to software contained on CI module.
( 14)
• Select "Slot 1:" or "Slot 2:" and press [OK].
Follow the on-screen instructions.
• On-screen instructions may not correspond to the remote
control buttons.
• For more information about TV service, please contact
your service provider.
• Depending on the card, in some cases its use together
with this unit may be limited or not possible.
Network
Easy Network Setting
Press [OK] to start Easy Network Setting. (
94
SQT0802
91)
24)
Network Settings
LAN Connection Mode
Select the LAN connection method.
• When not using wireless LAN (when turning
it off), select "Wired".
Wireless Settings
This allows to set and check the connection
settings of the Wireless router.
Connection Setting
The Wireless router connection wizard will
be displayed.
Double Speed Mode Setting ( 2.4GHz )
When a 2.4 GHz wireless format is used,
this setting sets the connection speed.
• If you connect using the "Double Speed
Mode (40MHz)", 2 channels use the
same frequency band, and there is
consequently a greater risk of reception
interference. This can cause the
connection speed to drop or the
connection to become unstable.
IP Address / DNS Settings
Check the connection of the network or set
the IP address and DNS.
• To set the IP address and DNS
1 Set "IP Address Auto-assignment" and
"DNS-IP Auto-assignment" to "Off".
2 Select the item, then press [OK] to show
the respective setting.
• When the router's DHCP server function is
not activated, check the numbers of other
connected devices such as personal
computers, then assign a number different
from those of other devices for the "IP
Address" and assign the same number for
"Subnet Mask" and "Gateway Address".
Proxy Server Settings
Check and set the connection to the Proxy
server.
• Press [OK] to show the respective setting.