Troubleshooting; Troubleshooting Guide - Panasonic Diga Blu-ray DMR-BCT950 Operating Instructions Manual

Troubleshooting

Troubleshooting guide

Troubleshooting
Before requesting service, make the following
checks. If the problem still persists, consult
your dealer for instructions.
Updating to the latest software (firmware) may
solve the problem. (
The followings do not indicate a problem
with this unit:
• Regular disc rotating sounds or HDD rotating
sounds.
• Poor reception due to atmospheric conditions.
• When you switch the unit on or to standby
mode, there may be an unexpected sound.
General operation
The unit does not work.
• Check the connections. (
• One of the unit's safety devices may have been
activated.
Reset the unit as follows:
1 Press [Í/I] on the main unit to switch the unit
to standby.
• If the unit does not switch to standby, press
[Í/I] on the main unit for about 3 seconds.
The unit is forcibly switched to standby.
Alternatively, disconnect the AC mains
lead, wait one minute, then reconnect it.
2 Press [Í/I] on the main unit to switch it on. If
the unit still cannot be operated, consult the
dealer.
104
SQT0802
100)
16, 17)
Cannot eject a disc.
1 When the unit is Off, press and hold [OK], the
yellow button and the blue button at the same
time for more than 5 seconds.
• "00 RET" is displayed on the front panel
display.
2 Repeatedly press [1] (right) until "06 FTO" is
displayed on the front panel display.
3 Press [OK].
The remote control does not work.
• The remote control and main unit are using
different codes. Change the code on the remote
control.
Front panel display
Press and hold [OK] and the indicated number
button at the same time for more than
5 seconds. ( 97)
Startup is slow.
• Startup takes time in the following situations:
- A disc is inserted.
- The clock is not set.
- Immediately after a power failure or the AC
mains lead is connected.
- When a BD-J application is executing.
- When the "Quick Start" is not activated. ( 96)