Sanyo VCC-9400 Instruction Manual page 24

CAMERA SETTINGS
DNR setting
5
Use the joystick lever (j or l) to move the cursor to
DNR, and then use the joystick lever (d or c) to select
the digital noise reduction setting (example: ON).
Available settings:
• • • •
ON: DNR (digital noise reduction) is applied. This reduces
interference at low luminance levels.
• • • •
OFF: DNR is not applied.
Note: Digital noise reduction operates when the gain control
increases. In addition, blurring and ghosting of images
can occur when moving images are being monitored,
and so the resolution is also reduced slightly.
BURST setting
6
Use the joystick lever (j or l) to move the cursor to
BURST, and then use the joystick lever (d or c) to select
the burst setting (example: ON).
Available settings:
• • • •
ON: The color burst signal is turned on.
• • • •
OFF: This should normally be set to "OFF".
FOCUS setting
7
Use the joystick lever (j or l) to move the cursor to
FOCUS, and then use the joystick lever (d or c) to select
the focus setting (example: 1).
Available settings:
• • • •
1: Near-infrared wavelength correction is set.
(around 900 nm)
• • • •
2: Visible light spectrum is set.
Note: This should normally be set to "1". If images are out of focus
in black & white mode, select a mode that gives better focus.
English
D/N SETTING - AUTO
AGC MAX GAIN +9·
DNR ON
BURST OFF
FOCUS 1
LEVEL MID
D/N SETTING - AUTO
AGC MAX GAIN +9·
DNR ON
BURST ON
FOCUS 1
LEVEL MID
D/N SETTING - AUTO
AGC MAX GAIN +9·
DNR ON
BURST ON
FOCUS 1
LEVEL MID
–
LEVEL setting
8
Use the joystick lever (j or l) to move the cursor to
LEVEL, use the joystick lever (d or c) to select the level
setting (example: ADJ) and then press the ENTER button.
The LEVEL SETTING screen will appear.
ENTER
Available settings:
• • • •
LOW: The mode switches when the luminance of the
objects being monitored is comparatively dark.
• • • •
MID: The mode switches when the luminance of the
objects being monitored is between the LOW and
HIGH levels.
• • • •
HIGH: The mode switches when the luminance of the
objects being monitored is comparatively bright.
• • • •
ADJ: The switching level for color mode to black & white
mode and for black & white mode to color mode
respectively can be set manually.
9
Use the joystick lever (j or l) to move the cursor to
COLOR†B/W, and then use the joystick lever (d or c) to
select the value.
Available settings: 1 – 7
Note:
• • • •
The larger the value, the darker the switching level.
• • • •
Changing the setting for one of the switching level settings
(from color mode to black & white mode or from black &
white mode to color mode) causes the other setting to
change also.
• • • •
Set the switching level from black & white mode to color
mode in the same way.
23 –
D/N SETTING - AUTO
AGC MAX GAIN +9·
DNR ON
BURST ON
FOCUS 1
LEVEL ADJ ‚
LEVEL SETTING
(COLOR†B/W)
4
(B/W†COLOR)
4
PRESET OFF
MENU BACK
LEVEL SETTING
(COLOR†B/W)
4
(B/W†COLOR)
4
PRESET OFF
MENU BACK