Table of Contents
Advertisement
Chapter 8 Connecting to External Devices — Connection function via <USB2.0 DEVICE> or <USB3.0 HOST> terminal
[SELECTED PART.]
For [FAT] and [OTHER] (other storage devices)
[PARTITION]
[VENDOR]
[MODEL]
[SIZE]
[FREE CAP.]
[SELECTED PART.]
4 Partition or folder information
For [TYPE S] and [P2STORE] (partition information)
[NO.]
[MODEL]
[PARTITION NAME]
[DATE]
[TIME]
[SERIAL]
For [FAT] and [OTHER] (folder information)
[NO.]
[FOLDER NAME]
[DATE]
[TIME]
@
NOTE
t For [TYPE S] storage devices, you can switch the display between the partition name and serial name using the control stick.
t If there is an invalid partition in [P2STORE], the partition information is displayed in gray.
t The remaining free space of the corresponding partition can be checked in the main menu → [CLIP] → [PROPERTY] → [FREE CAP. OF
PARTITION].
Selecting the target folder/partition in the explorer screen
You can display all clips included in the selected partition/folder as thumbnails by selecting partitions/folders as targets. You can display up to six
partitions/folders. When the seventh partition/folder is specified, setting is disabled and a warning is displayed.
1
In the explorer screen, place the cursor on the partition/folder.
2
Press and hold the control stick (for one second or more).
The partition/folder is selected and a checkmark is displayed. (Fig. 1)
The selected target partition/folder is valid until the storage device is disconnected or the power is turned off. To release the selected partition/folder,
hold down the control stick (for one second or more) again on the selected partition.
Press the <CANCEL> button to deselect all partitions/folders.
@
NOTE
t In [TYPE S] storage devices, [MODEL] is [UNKNOWN] and clips recorded across other partitions will not be one normal clip. Copying clips to a [TYPE
S] storage device changes the partition of the copy destination [MODEL] to [UNKNOWN].
t The partition name can be set when a [TYPE S] storage device is used. The partition name that has been set is displayed in [PARTITION NAME] on
the explorer screen.
Number of partitions selected
[FAT]/[OTHER]
Vendor name
Model name
Total capacity (unit: GB)
Remaining capacity (unit: GB)
Number of folders selected
Displays a checkmark when a target partition is selected
Partition number
P2 card model name
Name assigned to the partition
Partition record date
Partition record time
P2 card serial number
Displays a checkmark when a target partition is selected
Folder number
Folder name (excluding the CONTENTS folder)
Folder creation date
Folder creation time
Fig. 1
– 156 –
Advertisement
Table of Contents
