Download Table of Contents Print this page

Makita LXDT03 Instruction Manual page 6

Hide thumbs Also See for LXDT03:

Advertisement

Table of Contents
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
Reversing switch action
A
1
012017
This tool has a reversing switch to change the direction of
rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for
counterclockwise rotation.
When the reversing switch lever is in the neutral position,
the switch trigger cannot be pulled.
CAUTION:
Always check the direction of rotation before
operation.
Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the
reversing switch lever to the neutral position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
12 mm
(15/32")
001266
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
1. Reversing
switch lever
B
9 mm
(3/8")
1
2
012009
To install the bit, insert the bit into the sleeve as far as it
will go.
1
2
012063
To remove the bit, pull the sleeve and pull the bit out.
NOTE:
If the bit is not inserted deep enough into the sleeve,
the sleeve will not return to its original position and
the bit will not be secured. In this case, try
re-inserting the bit according to the instructions
above.
When it is difficult to insert the bit, pull the sleeve
and insert it into the sleeve as for as it will go.
After inserting the bit, make sure that it is firmly
secured. If it comes out, do not use it.
Hook
1
012014
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw. To
remove, loosen the screw and then take it out.
1. Bit
2. Sleeve
1. Bit
2. Sleeve
1. Hook
2. Screw
2

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lxdt04

Table of Contents