Miele KM 3054 Operating And Installation Instructions page 31

Problem Cause
The burner ignitor The circuit breaker has
is not working tripped.
There is food residue
between the ignitor and
the burner cover.
One of the
following error
messages
appears on the
timer display:
LC
The start-up lock is
activated.
FL
Sensor error
F2
The overheating
(the operating/ protection has
residual heat triggered
indicator is
flashing)
E0
Electronics fault
(The operating/
residual heat
indicator is
flashing)
All other An error has occurred
error messages with the electronics.
Frequently asked questions
Solution
Restore power.
If lack of power is the problem, the cooktop can be lit with
a match. See "Turning on in the event of a power failure".
Clean carefully (see "Cleaning and care").
Deactivate the start-up lock (see chapter "Start-up lock").
First make sure there is no direct light (sunlight or artificial
light) falling on the cooktop and that the surroundings of
the cooktop are not too dark.
Make sure that the entire cooktop and the touch controls
are not covered. Remove any cookware and clean the
cooktop of any residues.
Turn off the power supply of the cooktop for
approx. 1 minute.
If the problem persists, please contact technical service.
None!
Turn all burner control knobs to the right to "ß". You can
use the burners again when F2 goes out.
Reset: Press the touch control of the quick switch-off for
3 seconds.
If the problem persists, please contact technical service.
Yurn off the power supply of the cooktop for approx. 1
minute.
If the problem persists after restoring the power supply,
please contact technical service.
31