Prepare The Remote Control; Install Radio Stations Automatically; Set Clock - Philips FX25 User Manual

Audio system
Hide thumbs Also See for FX25:
Table of Contents

Advertisement

Prepare the remote control

Note
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
Danger of explosion if the battery is incorrectly
replaced. Replace only with the same or equivalent
type.
1
Open the battery compartment.
2
Insert one AAA battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
If you are not going to use the remote control for a
long time, remove the battery.
Batteries contain chemical substances, so they should
be disposed of properly.
Install radio stations
automatically
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1
Connect the unit to power supply.
» [AUTO FM INSTALL - PRESS PLAY--
STOP CANCEL] (auto FM install
- press PLAY to start - press STOP to
cancel) is displayed.
2
Press
to start installation.
» [AUTO] (auto) is displayed.
» The unit automatically stores radio
stations with sufficient signal strength.
» When all the available radio stations
are stored, the first preset radio station
is broadcast automatically.

Set clock

1
In standby mode, hold CLOCK for more
than two seconds to activate clock setting.
» 'CLOCK SET' is displayed. Then, the 12
hour or 24 hour format is displayed.
2
Press
/
repeatedly to select 12 hour
or 24 hour format.
3
Press CLOCK to confirm.
» The hour digits are displayed and begin
to blink.
4
Press
/
repeatedly to set the hour,
then press CLOCK to confirm.
» The minute digits are displayed and
begin to blink.
5
Press
/
repeatedly to set the minute,
then press CLOCK to confirm the set
clock.
Tip
During setting, you can press
without saving the earlier operation.
During setting, if no action is taken within 90 seconds,
the device exits clock setting automatically without
saving the earlier operation.
During play or in ECO Power standby mode, you press
CLOCK to view the set clock.
to exit clock setting
EN
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fx25/12

Table of Contents