Table of Contents
Advertisement
Cleaning The Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting grill.
1.
Turn gas off at control knobs and LP tank.
2. Remove cooking grate and V-bar.
3. Remove grease can from beneath grill. Beneath grill bottom,
disconnect ignitor wire from electrode.
4. Remove screw holding collector box. Note which hole on
collector box used for attaching to burner. Remove collector
box and clean ceramic portion of electrode with rubbing
alcohol and cloth.
5. Under control panel, disengage burner springs from burner
tubes.
Do not remove springs from valves
6. To remove burner, slide backwards, lift up and out of grill.
7. Clean outside of burner with soap and water. Lay burner
upside down on flat surface. Force a stream of water through
tubes. Make sure water comes out of all burner holes. Open
clogged holes with a thin wire.
examine holes. Due to normal wear and corrosion, some
holes may become enlarged. If any large cracks or holes are
found replace burner.
8. If grill is to be stored, coat burner lightly with cooking oil.
Wrap in protective cover to keep insects out. If not storing grill
after cleaning, hold burner at an angle and insert into grill
bottom.
9. After cleaning, insert electrode into hole in grill bottom.
Reattach collector box to burner with screw.
correct hole.
10.Place end of spring into hole on underside of burner tube, as
before, to secure burner. See figure A.
VERY IMPORTANT: Burner tube must engage valve opening
as shown in figure A.
11. Reattach ignitor wire to electrode.
12. Reposition V-bar and cooking grate. Reattach clean can to
grease clip.
13. Before cooking again on grill, follow
s Do not use charcoal with this grill.
.
Shake out excess water
and
Be sure to use
"Burner Flame Check"
Screw
Collector
Box
Burner
.
A
Burner
Valve
Tube
Spring
Electrode
Ignitor
Wire
463845504 • 23
Advertisement
Table of Contents
