Fujitsu UTY-CDPXZC Design & Technical Manual page 17

3. Installing the remote controller:
• When attaching to switch box:
a. Seal the wiring hole of the remote controller cable.
b. Put a remote controller cable through the hole of the rear case.
c. Fix the rear case by securing with attached screws (2 places).
• When attaching to the wall directly:
a. Seal the wiring hole of the remote controller cable.
b. Put a remote controller cable through the back hole of the rear case of the main
body.
c. Fix the rear case by securing if with attached screws (2 places).
Trap
• When routing the cable on the wall:
a. Cut off the cable guide of the front case with using a knife or a nipper.
b. Deburr the edge of the cable guide.
c. Fix the rear case by securing it with attached screws (2 places).
Seal the wiring hole of the remote
controller cable with putty.
Remote controller cable
Box
Trap
Rear case
Seal the wiring hole of the remote
Wall
controller cable with putty.
Screws
Rear case
Remote controller cable
Rear case
- 13 -
Putty
Screws
Trap
Putty
Trap
Cut off
Front case
Epoxy putty
Screws