Troubleshooting Guide - Honeywell HM0CESAWK6 User Manual

TROUBLESHOOTING GUIDE

The following troubleshooting guide addresses the most common problems. If problems persist, call
customer support. Unplug and disconnect the appliance from the power source before attempting
to troubleshoot.
PROBLEM POSSIBLE CAUSE
No electricity.
The air
Batteries in the remote
conditioning
control need to be
unit does not
replaced.
start
The power cord is not
properly plugged in.
The thermostat
temperature setting
is too close to room
temperature.
Runs a short
Air outlet is blocked.
while only
There are tight bends in
the air hose.
In Heating
The room is too humid.
Mode*,the unit
Water Tank needs to be
keeps switching
emptied.
off frequently
SOLUTION
Check for power.
Change remote control batteries.
Remove and reconnect the power cord.
Lower the set temperature.
Make sure the hose is properly connected.
Connect hose as per instructions on page 3.
In heating mode, the heat pump condenses moisture
from the air into the internal water tank. In more
humid rooms, it will collect faster and need to be
emptied out more frequently. It is recommended to
use the heating mode in 50% humidity or less.
Switch off any appliances such as a humidifier or
kettle to avoid extra moisture build up in the room
when operating in heating mode.
*Applicable for models with Heating feature only.
EN 14