Instant Start; Settings - Electrolux Smart Service Manual

Operating instructions Variomix
Instant start (Fig.3)
• Press On/Off for 1.5 seconds. The display is lit.
The following text appears in the display:
MENU SETTINGS
I I
I I
V V
The pan should be in working position. (See Tilting/Tilt
return).
• Press START . The red LED comes on and glows
steadily.
The following text appears in the display:
BOILING
-h --min XXX°C
AGITATOR 000rpm
The pan starts and the pan temperature automatically ri-
ses to 100°C.
To use agitator (See Agitator).

Settings

If you do not want to go through all the stages, you can
press START at any time during programming to start
the process.
• Press On/Off for 1.5 seconds. The display is lit.
The following text appears in the display:
The arrow points to the associated function button.
MENU SETTINGS
I I
I I
V V
•
Press Menu forwards
pears in the display:
BOILING
-h --min XXX°C
AGITATOR 000rpm
•
Press Menu forwards
ves appear in the display:
MANUAL FILLING
WATER
1.
Press Increase value
filling with water.
6
once. The pan's status ap-
once. The following alternati-
once and the pan starts
•
Press Decrease value
pan stops filling with water.
If Menu forwards is activated before filling with water
has stopped, filling is interrupted with STOP
BOILING
SET TEMPERATURE
XXX°C
2
Press Increase value
(max. 121°C) or press Decrease value
the temperature (min. 30°C).
• Confirm by pressing Menu forwards
lowing alternatives appear in the display:
BOILING
SET TIME
-h --min
3.
Press Increase value
time (max. 7h 59 min) or shorten the time by pressing
Decrease value .
If the display shows - h -- min this means unlimited time
and the pan must be switched off with STOP
• Confirm by pressing Menu forwards
The following settings appear in the display:
BOILING
-h --min XXX°C
AGITATOR 000rpm
4.
Press START to start. The red LED comes on and
glows steadily.
The boiling time starts when the set temperature has been
reached.
NOTE! Temperatures above 100°C cannot be reached, and
the counting down of boiling time will not then start.
When the boiling time is over, the heat is switched off.
The red LED goes out and a buzzer sounds in 2 mintes
and the display flashes until the pan is switched off,
which is done as follows:
5
Press STOP .
The following alternatives appear in the display:
INTERRUPT?
YES PRESS STOP
NO PRESS START
• Press STOP , the red LED goes out.
rpm = revolutions/minute
or STOP once and the
.
to increase the temperature
to reduce
once. The fol-
to set the desired boiling
.
once.