Install The Hdd; Install The Hdd1 - Clover CDR-4170 Instruction Manual

10. To complete, click Add Host on the bottom.
11. After registration, go to the DDNS SET menu on the DVR.
12. Refer to section 5.11 DDNS in this manual for the next step.
Registration to CLOVERDVR.COM
1. Go to website www.cloverdvr.com
2. Select Insert New User.
3. Enter your ID and Password (up to 8 digits), and press Submit.
4. New ID will be created.
5. Press Go Home.
6. Select View User.
7. Enter your ID and Password and press Submit.
8. Now you can see the ID, Domain and IP address.
9. After registration, go to the DDNS SET menu on the DVR.
10. Enter the registered ID to the HOST NAME and USER NAME in the DDNS SET
menu.
11. Refer to section 5.11 DDNS in this manual for the next step.

6. INSTALL THE HDD

6.1 INSTALL THE HDD1

DVR manufacturer already installed a 160GB of HDD1 as MASTER in the removable HDD rack.
Just in case, refer to the following explanation on how to install HDD (Hard Disk Drive).
CAUTION The power switch must be turned off before installing.
1. Separate the removable HDD rack from the system.
2. Refer to the HDD manufacturer's directions on how to set the jumper for master or slave when
assembling.
3. Make sure the power connector and the flat cable are properly connected.
4. Attach the HDD to the removable HDD rack and secure it with the supplied screws as below.
Removable HDD Rack
USB
- 37 -
REC PLAY TIMER ALARM FULL POWER
CH1 CH2 CH3 CH4 QUAD
AUTO POP PIP
ENTER REC
ESC SETUP SEARCH BACKUP STOP REW PLAY FF
ALRST PTZ A-LIST WTMK PAUSE