Switch Action - Makita SP001G Instruction Manual

Positive stopper
The positive stopper is useful for setting the designated angle
quickly. Turn the positive stopper so that the arrow on it points
22.5°. Loosen the clamping screws in front and back. Then tilt the
blade until it stops and secure the base with the clamping screws.
► 1. Positive stopper 2. Clamping screw
48°-bevel cutting
To perform 48°-bevel cutting, loosen the clamping screws and
fully tilt the lever toward the direction of the arrow in the figure.
Then set the bevel angle to 48° and tighten the clamping screws.
► 1. Lever
-1°-bevel cutting
To perform -1°-bevel cutting, loosen the clamping screws and
press the levers toward the direction of the arrow in the figure.
Then set the bevel angle to -1° and tighten the clamping screws.
► 1. Lever
1
2
1
Sighting
1
► 1. Base
The cutting line varies depending on the cutting angle
and whether you use the guide rail (optional accessory).
When using the tool without guide rail
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the
B position with it.
When using the tool with guide rail
For both straight cuts and 45° bevel cuts, always align the
A position on the front of the base with your cutting line.

Switch action

WARNING:
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
WARNING:
by taping down or some other means. A switch with
a negated lock-off button may result in unintentional
operation and serious personal injury.
WARNING:
you simply pull the switch trigger without press-
ing the lock-off button. A switch in need of repair
may result in unintentional operation and serious
personal injury. Return tool to a Makita service center
for proper repairs BEFORE further usage.
To prevent the switch trigger from being accidentally pulled, a lock-
off button is provided. To start the tool, depress the lock-off button
and pull the switch trigger. Release the switch trigger to stop.
1
► 1. Switch trigger 2. Lock-off button
10 ENGLISH
A B
Before installing the battery car-
NEVER defeat the lock-off button
NEVER use the tool if it runs when
2
1