Advertisement
II.
ASSEMBLY PARTS AND TOOLS
Note: We recommend the purchase of the end cap removal and Cartridge Removal
tools for cartridge replacement. Instructions in this guide assume these tools
are being used.
A.
End Cap to Cartridge
Connector (2)
Part #50633
Included in Kit #223
B.
Cartridge O-rings (2)
Part # 50618
Included in Kit #223
C.
Connector O-rings (8)
Part #50619
Included in Kit #223
D.
End Cap O-rings (2)
Part #50617
Included in Kit #223
E.
Cartridge Removal Tool
Kit #K218
F.
End Cap Removal Tool
Part #50619
Included in Kit #223
A 10 mm wrench and 5 mm hex key are also needed for this procedure. A small
plastic hammer may also be needed. These tools are not provided.
Stainless steel adapter component inserted into the
end cap that properly fits into the cartridge's center
tube.
NOTE: Only one connector will be used if only one
end cap is removed during cartridge replacement.
2-263 O-rings are used to seal the cartridge to the
vessel. One O-ring is used for each end of the
cartridge.
2-124 O-rings are used to seal the end cap
connector to the end cap and cartridge.
2-442 O-rings are used around the outer edge of
the end cap.
Custom tool used to extract and insert cartridges
(sold separately).
Tool used to remove the end cap from the vessel
(sold separately).
E
4
A
B
C
D
F
Advertisement
