Inserting Or Removing Microsd Card - LG MultiSITE VM3 Startup Manual

Hide thumbs Also See for MultiSITE VM3:
Table of Contents

Advertisement

COMMISSIONING OVERVIEW

Inserting or removing microSD card

Typically, the microSD card that ships with a new controller is inserted in the unit prior to the mounting process. However, it is possible to
move an SD card from one unit to another. For example, you might want to remove the SD card from a unit that suffered a hardware failure
and use it in a replacement unit.
Prerequisites
• All power to the controller must be removed before inserting/removing the microSD card. Otherwise equipment damage may occur.
• The controller must be unmounted from any DIN rail or screw tab mounting, as accessing the card uses space behind the mounting base.
• Discharge any static electricity that you may have accumulated by touching a known, securely grounded object.
• Data on the microSD card is encrypted by a "system passphrase" stored in the controller base. The passphrase on the card must match
the passphrase stored in the controller. If swapping in a card from a previously configured unit, you must provide the passphrase (of the
previously configured unit which is stored on this SD card) using a serial connection to the unit's Debug port.
Steps
1. Carefully slide the plastic microSD card shutter open.
The shutter must remain captive in the base, revealing the microSD card socket.
Shutter access to MicroSD card
1:
Card socket
2:
MicroSD card
3:
2. Make either of the following changes, as needed:
• Insert the microSD card by sliding the card into the card socket, label side up, until the spring catch engages. If properly inserted, the card
is behind the shutter track.
• Remove the microSD card by pushing the card in, until the spring release pushes the card partially out of the card socket. Grasp the card
and pull it completely out of the unit. Store the microSD card in a static free protective case.
3. Carefully slide the card shutter back over the card socket opening, until it clicks into place.
• When properly closed, the shutter must not protrude behind the mounting base.
12
Figure 2: MicroSD card slot in Controller.
1
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
2
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pbacnbtr1a

Table of Contents