Connecting Power - Siemens RUGGEDCOM RS1600F Installation Manual

Rugged ethernet switches
Hide thumbs Also See for RUGGEDCOM RS1600F:
Table of Contents

Advertisement

Installing Device
2.2 Connecting Power
To mount the device to a panel, do the following:
1.
2.
2.2

Connecting Power

The RUGGEDCOM RS1600F supports single or dual redundant high AC, high DC
and/or low DC power supplies. The use of two power modules is recommended to
provide redundancy and load balancing.
The RUGGEDCOM RS1600F can be equipped with either a screw-type or pluggable
terminal block, which provides power to both power supplies. The screw-type
terminal block is installed using Philips screws and compression plates, allowing
either bare wire connections or crimped terminal lugs. Use #6 size ring lugs for
secure, reliable connections under severe shock or vibration.
IMPORTANT
8
Place the device against the panel and align the adapters with the mounting
holes.
1
1
Screw
1
Panel/DIN Rail Adapter
2
Figure 2.3
Panel Mounting
Install the supplied screws to secure the adapters to the panel.
For maximum redundancy in a dual power supply configuration, use two
independent power sources.
RUGGEDCOM RS1600F
Installation Manual, 01/2021, C79000-G8976-1014-03
2

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simatic net ruggedcom rs1600f

Table of Contents