Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes From Motor Unit Memory; 3-Button Remotes - Chamberlain Whisper Drive Security+ 459950 Owner's Manual

Chamberlain whisper drive 459950 garage door openers: user guide
Hide thumbs Also See for Whisper Drive Security+ 459950:
Table of Contents

Advertisement

Available languages

Available languages

PROGRAMMING

NOTICE: If this Security ✚
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚

To Add or Reprogram a Hand-held Remote Control

USING THE "LEARN" BUTTON
1. Press and release the "learn" button
on the motor unit. The learn indicator
light will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote
you wish to operate your garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote,
first erase all codes:
Press and hold the purple "learn" button
on motor unit until the learn indicator
light goes out (approximately
6 seconds). All previous codes are now
erased. Reprogram each remote or
keyless entry you wish to use.
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in
* that
USING THE SMART CONTROL PANEL™
1. Press the Prog <Learn> button on the
Smart Control Panel™.
2. Press the Prog <Learn> button again
to confirm Learn Mode.
3. Press the button on the hand-held
remote
* that you wish to operate your
garage door.
4. When the motor unit lights blink, it has
learned the code. If light bulbs are not
installed, two clicks will be heard.
*3-Button Remotes (315Mhz)
If provided with your garage door
opener, the large button is
factory programmed to
operate it. Additional
buttons on any Security✚
3-Button remote or
compact remote can be
programmed to operate
®
other Security✚
garage
door openers.
38
®
remote controls.
®

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents