Advertisement
Quick Links
Model Series 874
Plug-In Light Control
The Plug-In Light Control is designed to operate lights according to the Rating Chart shown below. Please read
the instructions and power limitations carefully to ensure proper use and maximum safety. NOT recommended
for use with toasters, coffee pots, or halogen lighting systems.
Light Control products can be operated by portable remote control Model Series 50, 60, 70 and 80 by Model
Series 740 Keyless Entry.
WARNING
The Light Control is for indoor use only.
Exposure to moisture can cause electric shock
or fire.
Unplug receiver before opening cover to
set/change code.
The Plug-In Light Control receiver needs to learn the remote control code. Follow the instructions below:
• Select a remote control push button to operate the
light control.
• Pry up the lower edge of the actuator with a coin or
screwdriver as shown.
• Plug the light control into a 120 Vac polarized
outlet. The plug contacts are designed for
polarized outlets only. The green power indicator
light will turn on if there is power to the outlet.
• Press and hold the remote control push button you
chose to activate the light control.
• Then press and release the "SMART" button on the
receiver with a pen or pencil tip. The adjacent
green indicator light will FLASH once.
• Release the remote control push button. Code
setting is now complete. Snap actuator back on
light control.
If the remote control push button is not held down
until the receiver indicator light flashes, the light
control will not accept the remote's code.
If the receiver "SMART" button is pressed and held
until the green indicator light alongside goes out (in
about 6 seconds), all memorized codes will be
erased.
• First, plug the lamp into a wall outlet and turn it ON.
• With the lamp still in the ON position, plug it into
polarized outlet on the light control. The bulb will
not light.
• TO TEST: Press and release the light control
actuator. The light should turn ON. Press the
remote control push button. The light should turn
OFF.
If two or more light products are installed, the
receivers must be located at least 10 feet apart to
prevent electronic interference.
114A1568E
To comply with FCC rules, adjustment or modification of receiver and/or
transmitter is prohibited, except for changing the code setting and replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Resistive Load .....................................1200 Watts
Motor Load..................................................1/3 HP
Incandescent Lamp ...............................600 Watts
Select a Remote Control push button
OPERATING INSTRUCTIONS
If the remote control does not activate the light, check
to be sure:
• You are pressing the remote control push button
selected to operate the light control.
• The remote control battery has power. The test
light on the remote control should glow when the
push button is pressed. Refer to the remote control
instructions for battery changing information.
© 1995 The Chamberlain Group, Inc.
All Rights Reserved
RATING
Actuator
Representative Remote Control
to operate the light control
120VAC
Polarized
Power
Wall Outlet
Indicator
Light
Green
"SMART"
Indicator
Button
Light
Printed in Mexico
Advertisement
