Electrolux EUC2245AOW User Manual page 12

Table of Contents

Advertisement

Available languages

Available languages

12
www.electrolux.com
Problem
A
or
shown instead of numbers
on the Temperature Dis‐
play.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the "FastFreeze",
or after changing the tem‐
perature.
Temperature cannot be
set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Temperature sensor
symbol is
problem.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The "FastFreeze func‐
tion" is switched on.
This is normal, no error
has occurred.
The "FastFreeze func‐
tion" is switched on.
The appliance is in dem‐
onstration mode.
The temperature regula‐
tor is not set correctly.
The food products' tem‐
perature is too high.
The door has been
opened often.
Solution
Contact the nearest Author‐
ised Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
Refer to "Operation".
Wait few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze func‐
tion".
The compressor starts after
a period of time.
Switch off "FastFreeze func‐
tion" manually, or wait until
the function resets automati‐
cally to set the temperature.
Refer to "FastFreeze func‐
tion".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera‐
ture.
Let the food products tem‐
perature decrease to room
temperature before storage.
Open the door only if neces‐
sary.

Advertisement

Chapters

Table of Contents
loading

Table of Contents