Celestron PowerSeeker Square 60 Quick Setup Manual

PowerSeeker 2 60
Item# 21028
1
Your PowerSeeker 60 includes: optical tube; tripod
with center support bracket ; three eyepieces; a 3x
barlow lens, finderscope and bracket; eyepiece
accessory tray; telescope carrying case; accessory
case; The Sky™ CD software; owner's manual.
4
Extend each of the three tripod legs down 6-8".
All three legs should be the same length to
provide a level platform for the telescope.
7
Thread the tray into the threaded hole in the
center of the leg brace.
Item #31132
Celestron Technical Support: 310
2
To set up the tripod, spread the legs outward
until they are fully extended and push down
center locking brace.
5
Use the three tightening clips located on each
leg to secure the extended legs in place.
8
Place optical tube on mount as shown above.
Line up hole on tube with the mounting screw
on the tripod head.
Questions or Problems with Set-up?
CONTACT:
Quick Set-up Guide
3
To extend tripod legs, open each tightening clip
to release the tripod leg.
6
Place the accessory tray on top of tripod's
center leg brace.
9
To attach the tube to the mount, thread the
screw into the mount using the threaded
adapter on the bottom of the tube.
. .
803 5955