Celestron PowerSeeker 76 Quick Setup Manual

PowerSeeker 76
1
Your PowerSeeker 76 includes: optical tube with
two threaded mounting bolts; tripod with center
support bracket & yolk mount attached; two
eyepieces; a 3x barlow lens, finderscope; slow
motion control rod; eyepiece accessory tray; multi-
tool (see step #7);The Sky™ CD software;
documentation including an owner's manual.
4
Once the tripod legs have been extended, it
may be necessary to tighten the nuts at the
top of each leg so they are tight & secure.
7
Secure the tube to the mount using the two
threaded mounting bolts. Tighten to secure in
place.
Celestron Technical Support: 310
Item# 21044
2
To set up the tripod, spread the legs outward
until they are fully extended and push down
center locking brace. Extend the center portion
of each of the three tripod legs down 6-8".
5
Place the accessory tray on top of tripod's
center leg brace. Thread the tray into the
threaded hole in the center of the leg brace.
8
Insert the slow motion control rod into the
eyebolt attached to the altazimuth mount.
Questions or Problems with Set-up?
CONTACT:
Quick Set-up Guide
3
Use the three tightening screws located at the
bottom of each leg to secure the extended legs
in place. All three legs should be the same
length to provide a level platform for the
telescope.
6
Locate the optical tube and line up the tube
with the holes on the mount.
9
Secure slow motion control rod to telescope
tube by attaching the included bolt and
tightening.
. .
803 5955