Troubleshooting - Husqvarna P 520DX Operator's Manual

2. Lift the product to release the pressure in the
articulated steering. The illustration shows where to
put the supports.
CAUTION:
support does not cause damage to the
control stay or causes a blockage of the
articulated steering.
3. Lubricate the articulated steering bearing again while
the product is lifted.
4. Lower the product.
To lubricate the drive shaft
1. Remove the service hatch. Refer to
service hatch on page 30 .

Troubleshooting

If you cannot find a solution to your problems in this
manual, speak to your Husqvarna service agent.
Problem
The starter motor does not turn the
engine over
The engine does not start when the
start motor turns the engine over
50
Make sure that the
To remove the
Troubleshooting
Cause
The PTO-button is activated.
The parking brake is not applied. Refer to
brake on page 26 .
The main fuse is blown. Refer to
The ignition lock is defective.
The connection between the cable and the battery is bad.
The battery is too weak. Refer to
The starter motor is defective.
There is no fuel in the fuel tank. Refer to
There is air in the fuel system.
Preheating is defective or too short
The engine is defective.
The fuel filter clogged.
2. Lubricate the 4 grease nipples with a grease gun
until grease comes out.
To apply and release the parking
To replace a fuse on page 37 .
To charge the battery on page 38 .
To fill fuel on page 19 .
To replace the fuel filters on page 34 .
1593 - 002 - 22.12.2020