Make sure a battery is installed before
disconnecting the unit from the power outlet or the
greeting and programmable information will need to
be recorded and entered.
Clean the plastic cabinet with a clean soft cloth
only. Do not use excess water or cleaning liquid
of any kind.
To reduce the risk of fire or injury to persons, read and
follow these instructions:
1. Use only a 9V carbon zinc or alkaline, 1604 or
1604A size battery.
2. Do not dispose of the battery(ies) in a fire. The cell
may explode. Check with local codes for possible
special disposal instructions.
3. Do not open or mutilate the battery(ies). Released
electrolyte is corrosive and may cause damage to the
eyes or skin. It may be toxic if swallowed.
ake sure the
4. Exercise care in handling batteries in order not to
short the battery with conducting materials such as
rings, bracelets and keys. The battery or conductor
may overheat and cause burns.
5. Do not attempt to recharge the battery(ies)
provided with or identified for use with this product.
The batteries may leak corrosive electrolyte or explode.
a two line
6. Do not attempt to rejuvenate the battery(ies)
provided with or identified for use with this product by
heating them. Sudden release of the battery electrolyte
may occur causing burns or irritation to eyes or skin.
7. When replacing batteries, all batteries should be
replaced at the same time. Mixing fresh and
discharged batteries could increase internal cell
pressure and rupture the discharged battery(ies).
(Applies to products employing more than one
separately replaceable primary battery).
es, such as a
8. When inserting batteries into this product, the
re a separate
proper polarity or direction must be observed. Reverse
insertion of batteries can cause charging, and that may
result in leakage or explosion. (Applies to products
employing more than one separately replaceable
9. Remove the batteries from this product if the
product will not be used for a long period of time
(several months or more) since during this time the
battery could leak in the product.
10. Discard "dead" batteries as soon as possible since
orm to order
"dead" batteries are more likely to leak in a product.
11. Do not store this product, or the batteries provided
with or identified for use with this product in high
temperature areas. Batteries that are stored in a freezer
or refrigerator for the purpose of extending shelf life
should be protected from condensation during storage
and defrosting. Batteries should be stabilized at room
temperature prior to use after cold storage.
Comience a hablar a una distancia de
Recorded messages are cut off.
The TA-119 is designed to disconnect from the
line after a caller stops talking. Calls may be
cut off if a five second pause is detected, if the
caller does not speak loud enough, or if the
message is less than four seconds.
The TA-119 does not respond when you
enter your remote access code during the
Try re-entering the correct code after the beep.
Between messages there is an operator
recording or a beep and dial tone.
The caller has hung up without leaving a
message. A shorter greeting will reduce the
frequency of these recordings.
You have more than one telephone number
and are experiencing difficulty.
See "MULTI-LINE INSTALLATION."
There is no sound during playback.
Check and adjust the VOLUME CONTROL.
The unit does not automatically stop playing
the greeting or recording a message when
you pick up an extension phone.
Hang up the phone and then answer the call
again after two seconds to allow the answering
system to detect the extension phone.
FACTORY SERVICE CENTERS
CASIO PHONEMATE, INC.
Attn: Customer Service
20665 Manhattan Place
Torrance, CA 90501
Should you have additional questions, please call Casio PhoneMate's Helpline at (310) 320
Design and specifications are subject to change without notice.
20665 Manhattan Place, Torrance, CA 90501
Internet Web Site: http://www.casiophonemate.com
U.S. Patents: 5,289,529; 5,400,393; 5,588,046; 5,606,598; 5,680,075; 5,692,04
IMPORTANT! SALES SLIP OR EVIDENCE OF PURCHASE DATE REQUIRE
The TA-119 does not respond w
ANNOUNCE ONLY button is pres
Make sure you are pressing and
the button for at least 2 seconds
After several attempts the TA-1
To reset the TA-119, unplug the A
PLUG from the back of the TA-11
seconds and remove the battery
installed). The greeting, incomin
and time/day stamp will be lost.
greeting and set the time and da
If this action does not fix the pro
Casio PhoneMate Helpline. Casio
Helpline staff can often resolve p
recommend repair service when
Unless you live close to a Casio
Service Center, you may be requ
product to Casio PhoneMate for
the product to the service center
1. Package the unit in its origina
2. Include a clear and specific ex
3. Include your name, address, a
4. Provide a legible photocopy o
store receipt for warranty pur
CASIO PHONEMATE, IN
Attn: Customer Service
CASIO PHONEMATE, INC.
Printed in Malaysia
8805 Kelso Drive
Baltimore, MD 21221