Brother QC 1000 Operation Manual page 34

g
While holding the thread from the spool with
both hands, pull the thread through the lower
notch in the thread guide plate, then through
the upper notch. Hold the end of the thread
with your left hand, and then guide the thread
through the groove, following the arrows in
the illustration.
a
a
Shutter
h
Without passing the thread through the
needle bar thread guide, manually thread the
needle on the right side.
a
Needle bar thread guide
Note
The needle threader cannot be used. Manually pass the
thread through the eye of the needle from the front. If the
needle threader is used, damage to the machine may
result.
i
Press , or press
screen.
j
Select a stitch.
Note
If appears as
the twin needle cannot be used with the selected
stitch.
a
in the
after a stitch is selected,
LOWER/UPPER THREADING
k
Press to select the setting for twin
needle sewing.
* The stitch width becomes narrower than with single needle
sewing.
a
a
Single needle/twin needle setting
→
appears.
CAUTION
• Be sure to set the twin needle mode when using the
twin needle. Using the twin needle while the
machine is in single needle mode could cause the
needle to break, resulting in damage.
l
Press the "Start/Stop" button after lowering
the presser foot lever.
Memo
To change the sewing direction with the twin needle,
raise the needle from the fabric, raise the presser foot
lever, and then turn the fabric.
1
33