Winding The Bobbin - Brother PR-620 Operation Manual

APPENDIX —————————————————————————————————————————————————————

Winding the bobbin

Prepare the bobbin and the spool of bobbin thread.
Use cotton or spun polyester bobbin thread (from 74
dtex/2 to 100 dtex/2).
1 Align the groove in the bobbin with the spring
on the bobbin winder shaft, and set the
bobbin on the shaft.
1 Groove in the bobbin
2 Spring on the shaft
2 Set the thread spool on the spool pin.
1
2
1 Thread spool
2 Spool pin
190
3
2
4
1
Note
● When using a small spool, remove the
spool cushion and set the spool directly
onto the spool pin. Also use the included
spool cap to keep the small spool stable.
Pass the thread through the hole in the left of
the thread guide toward the front of the
winder.
1
1 Hole in the thread guide
Pass the thread around the tension disk as
shown in the illustration. Make sure that the
thread is correctly fed into the tension disk.
1 Tension disk