Specifying Jumpstitch Trimming / "Dst" Jump Codes For Trimming - Brother PR-620 Operation Manual

2
6 Repeat steps through
for the other boxes.
• To change the color specified in a box,
delete the previous color, and then specify a
new one.
■ Changing the color thread table
Set "DISPLAY EXPANDED THREAD COLOR" to
"ON", and then select the color thread. Refer to
page 146.
5
to specify colors
Specifying jumpstitch trimming /
"DST" jump codes for trimming
You can specify whether or not jumpstitches are cut.
In addition, when using Tajima embroidery data
(.dst), you can specify whether or not the thread is
cut according to the specified number of jump
codes.
ON: The machine cuts the upper and bobbin thread
before the jumpstitch. When Tajima embroidery data
(.dst) is used, the machine converts the "jump" code
to a trim code, based on the number specified on the
next line.
OFF: The machine does not cut either a jumpstitch
or the "jump" code in Tajima embroidery data (.dst).
When the machine is purchased, "ON" is selected
and the number of jumps is set to "3".
The "DST" thread trim settings can be specified from
the second page of the settings screen.
1 Touch (or
desired setting.
The key appears as
selected, and it appears as
"OFF" is selected.
• Each touch of the key turns the setting either
on or off.
Note
● This setting is not applied to the trimming of
threads between characters in alphabet
patterns. (Refer to "Trimming the threads
between characters" on page 125.)
Memo
● The number of jump codes cannot be
specified for data other than Tajima
embroidery data (.dst).
Using the Settings Key
) and select the
when "ON" is
when
149
6