Error Messages - Brother NV1000 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Error messages

When erroneous operations are performed messages and advice on operation will be displayed on the LCD.
Follow what is displayed. If you press
displayed, the message disappears.
CAUTION
● Be sure to rethread the machine. If you press
machine, the thread tension may be wrong or the needle may break and cause injury.
Error Message
or do the operation correctly while the error message is
(Start/stop button) without rethreading the
The upper thread has become tangled around the bobbin case, and the
needle is bent and hitting the needle plate, etc., so the sewing machine
stops (refer to page 166).
Upper thread broken.
Upper thread not set up correctly.
Upper thread has run out.
Either the start/stop button or the reverse/reinforcement stitch button
was pushed at a LCD screen other than the sewing LCD screen.
The start/stop button, reverse/reinforcement stitch button or thread
cutter button was pressed while the presser foot was raised.
on the LCD was pressed when no card was inserted.
A card that cannot be used with this product has been inserted, and you
tried to select a pattern from the card.
You tried to combine more than 70 decorative stitches, satin stitches,
cross stitches or combined utility stitches.
The start/stop button, the embroidery key, or the memory key is pressed
in embroidery mode, but the embroidery unit is not attached.
You tried a function that cannot be used when the embroidery unit is
attached.
You tried to select an embroidery pattern or change the layout when
the needle was down.
The machine is turned on while the needle is lowered and the
embroidery unit is attached.
Probable Cause
Troubleshooting 171
5