If the Found New Hardware or Found New
Hardware Wizard dialog box appears:
Remove the USB cable connected to
The dialog box may close. In this case, proceed
Click Cancel to quit the dialog box.
Proceed from .
TURN OFF THE PRINTER (A).
Make sure that the POWER lamp (B) has stopped
flashing and is off.
It takes about 1 minute until the printer turns off.
Turn on the computer, then insert the Setup CD-
ROM into the CD-ROM drive.
The setup program should start automatically.
If the program does not start automatically, double-click
the CD-ROM icon on the computer. When the CD-ROM
contents appear, double-click MSETUP4.EXE.
Go to Step .
Go to Step