Aligning the Print Head
Paper support
Paper output tray
Auto sheet feeder
Paper
guide
Paper thickness
lever
4
1 1 1 1
Open the paper support and pull out the
paper output tray.
2 2 2 2
Load the A4/Letter-sized plain paper,
aligning it with the right side of the auto
sheet feeder.
Ensure that the paper thickness lever is set to the left
position.
3 3 3 3
Pinch the paper guide and slide it
against the left side of paper.
4 4 4 4
Align the print head.
Ensure that the message requesting head alignment is
displayed on the LCD:
• iP6220D
Use the
buttons to select Yes and then press the
OK button.
• iP6210D
Use the
buttons to select YES and then press the
OK button.
The pattern is printed. It takes about four minutes to
finish printing, and the print head is aligned
automatically.
5 5 5 5
Ensure the pattern shown on the left is
printed.
The printer is now ready to use.
• If pattern is not printed successfully, refer to
"Aligning Print Head - Auto head align" in the
Direct Printing Guide.
• The pattern is printed in black and blue.