Canon PIXMA iP5000 Series Start Here

1
Unpack the Printer
1 Carefully remove all items from the box.
PIXMA iP5000 Series
Photo Printer
Photo Printer
Series
Quick Start Guide
Documentation and
Software Kit
PIXMA iP5000 Series
Print Head
Power Cord
BCI-6Y Yellow
BCI-6BK Black BCI-6M Magenta
BCI-3eBK Black BCI-6C Cyan
Ink Tanks
2
Prepare the Printer
1 Remove all shipping tape and clear plastic from
the printer.
2 Plug the power cord into the back of the printer
and connect the other end to a power outlet.
Press the POWER button. The printer will
initialize.
POWER
Button
POWER Lamp
3 Lower the front cover. Raise the top cover.
Lower the inner cover.
Top Cover
Inner Cover
Front Cover
4 The print head holder automatically moves to
the center. Remove the protective tape.
Protective Tape
Serial Number
5 Write down the serial number located to the
right of the print head holder. You will need
this later to register the product.
Serial Number
Location

Start Here

Easy Setup Instructions
3
Install the Print Head
1 Remove the print head from its package.
Tear at notch to open
Remove the orange protective cap from the
2
print head.
NOTE: Do not touch the print head nozzles and
the electrical contacts.
Print Head Nozzles
Electrical Contacts
3 Raise the print head lock lever.
4 Slide the print head into the holder.
The print head will rest at a slight angle.
Lower the print head lock lever and press it
5
down until it clicks into place.
click
4
Install the Ink Tanks
1 Peel back the orange tab and completely
remove the plastic wrapper from the Cyan Ink
Tank (BCI-6C).
2 Twist off and discard the orange protective cap.
NOTE: To avoid spilling ink, never press on the
sides of an ink tank.
Protective Cap
3 Insert the ink tank into the correct slot.
(Refer to the color guide on the print head lock
lever.)
Press down until the ink tank clicks into place.
click
4 Insert the remaining four ink tanks into their
assigned slots.
5 Close (a) the inner cover and then (b) the top
cover. Lift open the paper support and extend
the paper output tray.
IMPORTANT: Be sure to close the inner cover
completely, or the paper will not feed properly.
Paper Support
(a) Inner Cover
(b) Top Cover
Paper Output Tray
NOTE: The printer will perform a print head
cleaning. Wait until the POWER lamp displays a
steady green light before proceeding.
Series
Photo Printer
Connect the Printer
5
and Load Paper
IMPORTANT: Be sure the printer is off before
continuing, or the computer will attempt to
install the printer driver before the printer is
ready.
1 TURN THE PRINTER OFF.
Connect one end of the USB cable to the
2
computer, the other to the printer.
USB Port
USB Cable
USB Cable
USB Port
Remove the shipping tape from the paper
3
guide. Pinch the paper guide and slide it to the
left. Load a few sheets of blank paper into the
auto sheet feeder, then slide the paper guide
toward the left edge of the paper.
Auto Sheet
Feeder
Paper Guide
IMPORTANT: Print Head Alignment (Step 6)
requires that 8.5" x 11" paper is loaded in the
Auto Sheet Feeder (top paper feeder).
Continue with Step 6
on side two.