Canon PIXMA iP3000 Series Quick Start Manual page 74

Troubleshooting
Problem Possible Cause
Cannot Print to Incorrect page size
End of Job is selected
There is not enough
free space on the
hard disk
The size of the print
data is too large
Use reduced
printing is not
selected when
performing
automatic duplex
printing
70
Ensure that the page size setting matches the size of the paper loaded in the
printer:
Check the P P aper Size setting from within your application to ensure that it
matches the size of the paper loaded.
Check P P aper Size on the P P age Setup tab in the P P rinter Properties dialog box of
the printer driver (Windows) or the P P age Setup dialog box of the printer driver
(Macintosh) to ensure that it matches the size of the paper loaded.
Your operating system may be out of free disk space.
Check the available space on your computer's hard disk.
Check the size of the print data. For Windows XP and Windows 2000, if the size of
the data is too large, part of it may be lost. When the spool format is EMF, follow
the procedure below.
1. Open the P P rinter Properties dialog box.
2. On the M M ain tab, click P P rint Options.
3. Select the R R educe spool data size check box, and click O O K.
When R R educe spool data size is set, the print quality may be
degraded.
In automatic duplex printing, the printable area at the top of the page is 2 mm/
0.08 inches narrower than the usual area, therefore the bottom edge may not be
printed. To prevent this, select U U se reduced printing in the printer driver.
Print layout may be altered with the reduced printing function.
1. Open the P P rinter Properties dialog box.
2. Click P P rint Area Setup in the P P age Setup tab and select U U se reduced printing.
1. In the P P rint dialog box, select D D uplex Printing & Margin from the pop-up menu.
2. Select A A utomatic Duplex Printing, and select U U se reduced printing in P P rint
Area.
Try This