Loading Rolls In The Printer; Installing The Printer Driver (Mac Os X); Removing The Roll From The Printer - Canon imagePROGRAF iPF815 Basic Manual

You can load rolls in two positions, in the Roll 1 (Upper) and Roll 2 (Lower) holders. (iPF825 only)
• Remove any loaded paper that will not be used.
• Rolls: (→
• Sheets: (→
• If the Wheeled Output Stacker is installed, remove it in advance. (→"Using the Wheeled Output Stacker," User
Manual)
• If the Platen is dirty, clean inside the Top Cover . (→
• After pressing the Load/Eject button, you can refer to instructions on the Display Screen as you load the paper.
(→"Checking Instructions During Printer Operations," User Manual)
Load a roll in the printer (iPF825: in the Roll 1 (Upper) position)
1
Confi rm that a roll is selected as the paper source.
(→"Selecting the Paper Source," User Manual)
2
Open the Top Cover and lift the Ejection Guide .
3
Holding the Roll Holder so that the side with the white
gear faces the side of the Roll Holder Slot with a white
gear, load the Roll Holder shaft (a) into the grooves (b)
on both ends of the Roll Holder Slot .
• Be careful not to pinch your fi ngers between the Roll Holder shaft (a) and the guide grooves (b) when
loading rolls.
• See the following procedure for instructions on attaching the Roll Holder to the roll.
(→

Loading Rolls in the Printer

Load rolls in the printer as follows.

, Removing the Roll from the Printer)

, Removing Sheets)
, Attaching the Roll Holder to Rolls)
, If Paper is Soiled)
b
14
OK
b
a a