Wickes PSJ700 Quick Start Manual page 9

4. LED LIGHT (See Fig. C)
The tool is equipped with a LED work light (20) which will
illuminate while working. Switch on the tool, press the
LED light button (1) and the LED light will be on. Press
the LED light button (1) again, and the LED light will be
off.
5. BLADE FITTING (See Fig. D1-D3)
NOTE: Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance. Wear
protective gloves when assembling the saw blade. You
can only use the blade type shown in Fig D1. Don't use
other blade types.
INSERTING THE SAW BLADE
To open the blade holder rotate the ring clockwise
(Jigsaw upside down) and hold in position. Then fully
insert the blade into the blade holder slot with blade teeth
facing forward and release the ring, which will self rotate
and clamp over the top of the blade. Push the blade into
the blade holder again to ensure it is locked in position.
Ensure the edge of the blade is located in the groove of
the blade guide.
REMOVING THE SAW BLADE
To remove a blade, hold the blade and rotate the blade
holder ring clockwise then lift out the blade (blade could
be spring ejected).
Warning: Blade teeth are very sharp. For best
cutting results ensure you use a blade suited to
the material and cut quality you need.
Fig. C
Fig. D1
Fig. D2
1
Fig. D3
9
2