SAL VB 6200 Instruction Manual page 9

63. A Somogyi Elektronic Kft. certifies that this radio equipment conforms to directive No. 2014/53/
EU. Full text of EU Declaration of Conformity is available on the following address: somogyi@
somogyi.hu
64. Due to continuous improvements, the technical data and design may change without any prior
notice.
65. The actual instruction manual can be downloaded from www.somogyi.hu website.
66. We do not take the responsibility for printing errors which may occur, and apologize for them.
To prevent possible hearing loss, do not listen to it at high volme for extended period of time.
PRECAUTIONS
Cleaning
Use a soft, dry cloth and a brush for regular cleaning. To remove stronger stains, wet the cloth slightly
with water. Avoid scratching the display's surface; never wipe the display when it is dry, and do not
use a rough cloth to clean the display. Do not use detergents. Make sure no liquid gets inside the
product or onto the connectors.
Temperature
Before turning on the player make sure that the temperature inside the car is between 0 ºC and
+40 ºC, as the product is only guaranteed to operate properly within this temperature range. Extreme
weather conditions can damage the product.
Location, installation
When installing the product, make sure it will not be exposed to any of the followings: - direct sunlight
or heat (e.g. from the heating system), - moisture, high humidity, - a significant amount of dust,
- strong vibration
Warning! Manufacturer does not take responsibility for lost or damaged data, even if these data, etc.
have been lost during the use of this product. It is recommended to make a safety copy about the
data, tracks –located on the data storage- to your computer.
INSTALLATION (Only a specialist can install the device.)
● Depending on the vehicle's design, additional metal straps or other means of fastening may be
required. The manner of installation may differ from the instructions depending on the vehicle
model.
● Connect the appliance's wiring according to the instructions. Inspect the connectors in the vehicle
for suitability according to the wiring instructions in this manual. Make sure that the connections are
properly made and free of short circuits. The speaker wiring should be conducted properly.
● It is prohibited to connect any of the speaker wires to the vehicle's or batteries negative terminal/
grounding point. (e.g. black power cable or metal point on the vehicle)
● In order to protect audio system from external noises:
- Locate the device and lead the cables at least 10 cm far from the car dashboard-cables.
- Keep the battery power cables as far from any others as you can.
- Grounding cable should be connected securely to a clean surface of the car chassis, free from
paint, dirt and grease.
- In case of connecting noise reducer, place it as far as possible from the device.
9