Canon BJ-20 User Manual page 36

Canon bj-20: user manual
Table of Contents

Advertisement

check for low battery (page 105).
Notes
If the printer is connected to an AC outlet, when the printer starts
up, it automatically used the power supplied from the AC outlet,
even if the battery pack switch is switched on.
When power is supplied from the battery pack, the printer will
turn off automatically if it does not receive any data within 30
minutes.
Checklist for
System Start-operation
Routine
Operation
Make sure the printer is connected to your computer.
1
Turn on your computer.
2
Decide which printer power source to use:
3
To use AC power, plug the adapter into an AC outlet.
To use an installed battery pack, disconnect the AC adapter
from the printer. (Also make sure the battery pack is switched
on.)
Turn on the printer.
4
Load paper.
5
Make sure the ON LINE indicator lights.
6
The printer is ready for printing.
System shut down
Turn off the printer.
1
The BJ cartridge is recapped automatically.
Turn off the Computer.
2
Caution
Whenever you turn off the printer, always wait for 4 seconds or
more, before turning it back on again.
Traveling with the Printer
Remove the AC adapter and printer cable, but leave the BJ cartridge and
1
battery pack (Switch it off) in the printer.
If you plan to travel with the printer, take the following steps.

Advertisement

Table of Contents
loading

Table of Contents