Download  Print this page

Canon PIXMA MP160 User Manual Page 89

Canon pixma mp160: user guide.
Hide thumbs

Advertisement

Table of Contents
Message
CHECK INK
U140
CHECK PRINTER
If the ON/OFF Lamp (green) and Alarm Lamp (orange) flash alternately,
Note
disconnect the USB cable from the machine, and then turn the machine OFF
and then unplug the machine from the power supply for a while. Plug the
machine back in and turn the machine back ON.
If the problem remains, contact a Canon service representative.
<E> and <error code> are alternately displayed on the LED of MP160.
Message
E, 2
E, 3
E, 4
E, 5
E, 7
E, 8
E, 9
Chapter 10
The FINE Cartridge may not be the compatible with this machine. Install
the appropriate FINE Cartridge. If lines are misaligned or the resulting
output is not satisfactory, carry out the FINE Cartridge Alignment.
An error requiring servicing might have occurred. Turn OFF the machine,
and unplug the power cord of the machine from the power supply. After a
while, plug the power cord of the machine back in and turn ON the
machine. If the same error occurs, contact a Canon service representative.
Reload the paper correctly and press [Black] or [Color].
If paper has jammed in the machine, clear the jam, reload the paper in the
machine correctly and then press [Black] or [Color].
The ink may have run out. Replace the FINE Cartridge, and close the
Scanning Unit. If lines are misaligned or the resulting output is not
satisfactory, carry out the FINE Cartridge Alignment. If printing is in
progress and you want to continue printing, press [Black] or [Color]. Then
printing can continue under the ink out condition with the FINE Cartridge
installed. Replace the empty FINE Cartridge immediately after the printing.
The resulting print quality is not satisfactory, if printing is continued under
the ink out condition.
The FINE Cartridge may not be installed properly, or the Cartridge may not
be the compatible with this machine. Install the appropriate FINE
Cartridge. If lines are misaligned or the resulting output is not satisfactory,
carry out the FINE Cartridge Alignment.
Some FINE Cartridges are not installed in place. Install the FINE
Cartridges in the appropriate positions.
Ink absorber is almost full. Ink used for cleaning is absorbed in a ink
absorber placed in the machine. <E, 8> indicates that the ink absorber is
nearly full. Press [Black] or [Color] to cancel the error so that you can
continue printing. If this error occurs, replacement of the ink absorber and
maintenance of the machine are required. Canon recommends to contact
a Canon service representative as soon as possible. Once the ink
absorber becomes completely full, printing cannot be done until the ink
absorber is replaced.
Depending on the model or brand of your device, you may have to select a
print mode compliant with PictBridge before connecting the device.
You may also have to turn on the device or select Play mode manually
after connecting the device to the machine. Perform necessary operations
according to the instruction manual supplied with your device.
If the error is still unresolved, there is a possibility that you are using a
digital camera or digital video camcorder that is not supported by this
machine. Use a digital camera or digital video camcorder compatible with
this machine.
Action
Action
Troubleshooting
87

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments:
  • Wayne Bohannon Jan 18, 2019 04:52:
    Printer shows E 2 flashing. off/on green light flashing. Yellow alarm light flashing.
  • winnie Mar 04, 2018 06:13:
    not responding to any commands.
    on/off green light continues to blink
    erro​r blinking
  • mahmad Aug 22, 2015 01:25:
    CANONpixma​2840 bjulg lu lgthj حيب kihzd td ,dk],. 7