Saxby Lighting 46393 Instruction Leaflet

Commissioning
• Refit the cover on the terminal block.
• Push the jack connector into the socket on the head.
• The ceiling surface must be flat and smooth to ensure
a good fit.
• Push the spring clips upwards and fit into the ceiling
hole. See Fig 1.
• Push the unit up until firmly in position, ensuring that
no cables are trapped. See Fig 2.
• Ensure that the product is sitting properly in the hole.
• Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
Fitting/replacing bulbs
• The LED's in this product are non replaceable.
• We recommend cleaning with a soft dry cloth. Do
not use solvents or abrasive cleaners as these could
damage the finish.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Safety information
For your safety, always switch off the supply before cleaning.
www.saxbylighting.com
1.
2.
Iss.4 04042016
Saxby Lighting Ltd. BH23 3PE
Instruction leaflet
Form Recessed
46393, 51902