Download  Print this page

When Sewing Straight Stitches While Using The Side Cutter - Brother 882-S90/S91 Operation Manual

Computerized sewing and embroidery machine.
Hide thumbs

Advertisement

Table of Contents
SEWING THE STITCHES
d
Select a stitch.
e
Make a cut of approximately 20 mm
(approx. 3/4 inch) in the fabric.
a 20 mm (approx. 3/4 inch)
f
Position the fabric so that the right side of
the cut is on top of the guide plate and the
left side of the cut is underneath the presser
foot.
a Guide plate (lower knife)
b Presser foot
g
Thread the needle manually and pull out a
long section of the upper thread. Pass it
below the presser foot and pull it out in the
fabric feed direction.
b
a Presser foot
b Upper thread
66
a
a
b
a
h
Start sewing.
→ A seam allowance is cut while the stitching is sewn.
Note
If the width has been adjusted, turn the hand-
wheel by hand to check that the needle does
not touch the side cutter. If the needle touches
the side cutter, it might cause the needle to
break.
■ When Sewing Straight Stitches While
Using the Side Cutter
The seam margin should be approximately 5 mm
(approx. 3/16 inch).
a
a Seam margin
Memo
• The fabric will not be cut if the whole fabric is
simply spread out underneath the presser
foot guide plate. Set the fabric as explained
f
in step
from the previous section, and
then start sewing.
• One layer of 13 oz. denim can be cut.
• Clean the side cutter after use to avoid hav-
ing dust and scraps of thread build up on it.
• Add a small amount of oil as required to the
cutting edge of the cutter.

Advertisement

Table of Contents

   Related Manuals for Brother 882-S90/S91

   Related Content for Brother 882-S90/S91

This manual is also suitable for:

Innov-ís 4000dInnov-ís 4000

Comments to this Manuals

Symbols: 0
Latest comments: