Adjusting The Embroidery Speed; Selecting The Length Of Jump Stitch Not To Trim - Brother 882-S90/S91 Operation Manual

MAKING EMBROIDERY ADJUSTMENTS
b
Press
TRIM.
→ The key will display as
* The machine will not trim the thread before moving
to the next stitching.
■ Selecting the length of JUMP
STITCH not to trim
When the thread trimming function
turned on, you can select the length of the jump
stitch not to trim the thread. This function can be
turned on or off during embroidering.
Select a setting from 5 mm to 50 mm in 5 mm
increments.
* Your customized setting remains after turning off
and on the machine.
Press or
STITCH.
For example: Press
and the machine will not trim 25mm or less length
of jump stitch before moving to the next stitching.
Note
• If design has many trims it is recommended
to select a higher jump stitch trim setting in
order to reduce the amount of excess tails
on backside of fabric.
• The higher number of the jump stitch length
selected, the fewer number of times the
machine will trim. In this case, more jump
stitches remain on the surface of the fabric.
156
to turn off JUMP STITCH
to select the length of JUMP
to select 25mm (1 inch)

Adjusting the Embroidery Speed

a
Press
b
In the MAX EMBROIDERY SPEED display,
use
embroidery speed.
* You can choose from 3 different speed levels.
is
Memo
• SPM is the number of stitches sewn in one
minute.
• Decrease the sewing speed when embroi-
dering on thin, thick, or heavy fabrics.
• The sewing speed can be changed while
embroidery is being sewn.
• The maximum sewing speed setting does
not change until a new setting is selected.
The setting specified before the main power
is set to OFF remains selected the next time
that the machine is turned on.
• Decrease the sewing speed to 600 spm
when using a speciality thread like a metallic
thread.
c
Press
and Embroidery.
to change the maximum
.