Brother 882-S90/S91 Operation Manual page 160

c
Remove the appliqué material from the
embroidery frame, and then cut carefully
along the stitching. After cutting, remove all
of the stitching thread carefully.
* Carefully cut out the pattern on the outline you just
sewed. Do not cut inside the stitching line, as the
appliqué fabric will not be caught by the appliqué
stitch.
d
Place the base material into the embroidery
frame.
a Base material
e
Press the "Start/Stop" button to sew the
position of the appliqué.
* Use the same thread color you plan to use when
attaching the appliqué in step
a Position of appliqué
b Base material
→ The machine will sew around the position of the
appliqué and will then stop.
a
g
.
a
b
SEWING AN EMBROIDERY PATTERN
f
Apply a thin layer of adhesive or spray
adhesive to the back of the appliqué piece
and attach it to the appliqué position so that
it follows the seam of the outline.
Memo
If the appliqué material is a lightweight fabric,
you may want to use a fusible web on the back
to stabilize the fabric and for appliqué place-
ment. Fuse appliqué in place with an iron.
Do not remove fabric from the frame to iron
the appliqué material.
g
Press the "Start/Stop" button.
Memo
Some patterns may not show all three appli-
qué steps. Sometimes the "Appliqué" step will
be shown as a color.
→ The appliqué will then be completed.
h
Change the upper thread and then carry out
the rest of the embroidering.
Memo
• Some glue may get onto the presser foot,
needle, and needle plate at this time. Finish
embroidering the appliqué pattern and then
clean away the glue.
• For best sewing results clip all threads
between color steps.
5
149