Brother PCL Technical Reference Manual page 160

SC - Scale
<HP-GL/2>
SC [ X , X , Y
min max
SC [ X , X , Y
min max min
SC [ X , X , Y
min factor
X ; X coordinate of P1
min
Y ; Y coordinate of P1
min
Type ; type of scaling
Left ; percentage of unused space to be left to the left of the scaling area
bottom ; percentage of unused space to be left below the scaling area
X ; number of graphics units per user unit on the x-axis.
factor
Y ; number of graphics units per user unit on the y-axis.
factor
• This command turns scaling on and establishes a user unit coordinate system. The coordinate system is
specified relative to the points P1 and P2. The origin need not necessarily be at P1. Three different types
of scaling are available.
• The technical terms, user unit and graphics unit, as used in this manual are defined as follows:
User unit
Graphics unit
• All coordinates are in user units.
• Coordinate values for X
• X
, Y , X and Y
min min max
X and Y should be P2.
max max
• X
must be different from X
min
• Using this instruction without a parameter field turns the scaling off.
• Type can be 0, 1 or 2, which select scaling types known as anisotropic, isotropic and point factor scaling
respectively.
• Type 0 scaling (anisotropic scaling, the default) allows you to specify different sized x-axis and y-axis units.
Hence the area specified by X
• left and bottom settings have no effect in type 0 scaling.
• Type 1 scaling (isotropic scaling) forces x-axis and y-axis units to be the same size. As a result the area
specified by X , X
min max
defined by P1 and P2.
, Y [, type ]] [;] (Type = 0)
min max
, Y , type [ left, bottom]] [;] (Type =1)
max
Y [, type ]] [;] (Type = 2)
min factor
X ; X coordinate of P2
max
Y ; Y coordinate of P2
max
: the unit of the coordinates set by the SC instruction.
: the unit(1/1016 of an inch) of the coordinates not set by the SC instruction.
, X , Y , and Y
min max min max
specify the range of the X- and Y-axes. X
max
, and Y must be different from Y
max min
, X , Y , and Y
min max min
P1 (0,0)
, Y , and Y (the isotropic area) may not fit exactly into the rectangular area
min max
(0,0)
P1
CHAPTER 4 HP-GL/2 - 15
are given as real numbers.
and Y
min
.
max
will occupy the entire area defined by P1 and P2.
max
P2 (7,6)
(6,7)
P2
2006/05/31
value should be P1 and
min