Canon EOS 20D Instruction Manual page 75

¡
¡
Differences Between <d> and <1> (Full Auto)
¡
In both modes, you can freely change the automatically-set shutter
speed and aperture combination (program).
In the < d > mode, you can set or use the functions below, but not in the < 1 > mode.
¡
Shooting Settings
¡
AF mode selection
¡
AF point selection
¡
Drive mode selection
¡
Metering mode selection
¡
Program Shift
¡
Exposure compensation
¡
AEB
¡
AE lock with <A> button
¡
Depth-of-field preview
¡
Clear all camera settings
¡
Custom Function (C.Fn)
¡
Clear all Custom Functions
¡
Sensor cleaning
Flash Settings (Built-in flash)
¡
Flash On/Off
¡
FE lock
¡
Flash exposure compensation
Shifting the Program
¡
In Program AE mode, you can freely change the shutter speed and
aperture value combination (program) set by the camera while
maintaining the same exposure value. This is called program shift.
¡
To do this, press the shutter button down halfway, then turn the <6>
dial until the desired shutter speed or aperture value is displayed.
¡
Program shift is canceled automatically after the image is captured.
¡
If you are using a flash, you cannot shift the program.
If "30"" and the maximum aperture blink, it indicates
underexposure. Increase the ISO speed or use flash.
If "8000" and the minimum aperture blink, it indicates
overexposure. Decrease the ISO speed or use an ND
filter (optional) to reduce the amount of light entering the
lens.
Flash Settings (EX-series Speedlite)
¡
Manual/Stroboscopic Flash
¡
High-speed sync (FP flash)
¡
FE lock
¡
Flash ratio control
¡
Flash exposure compensation
¡
FEB
¡
2nd-curtain sync
¡
Modeling Flash
Image-Recording Settings
¡
RAW and RAW+JPEG selection
¡
ISO speed
¡
White balance selection
¡
Custom white balance selection
¡
White balance correction
¡
WB bracketing
¡
Color temperature setting
¡
Color space selection
¡
Processing parameter setting
d Program AE
75