Recharging The Battery - Canon EOS 1D Mark II N Instruction Manual

Recharging the Battery

To charge the Ni-MH Pack NP-E3, connect it to Ni-MH Charger NC-E2.
CHARGE Lamp A (red)
REFRESH (discharge)
Lamp A (orange)
REFRESH (discharge) Button
22
1
Connect the power cord.
Connect the AC plug to a power
outlet and connect the power cord to
the charger.
The <POWER> lamp will light.
2
Detach the protective cover and
connect the battery.
Connect the charger's charge/
discharge plug to the battery's socket.
Attach the cover to the battery
compartment cap and store it.
3
Recharge the battery.
When you connect the battery, the
recharging will start automatically and
the red <CHARGE> lamp will light.
It takes about 120 minutes to fully
recharge a completely exhausted
battery.
When the battery is fully charged, the
<CHARGE> lamp will blink quickly
(twice per sec.).
After recharging the battery,
disconnect it and unplug the power
cord from the power outlet.
POWER Lamp
CHARGE Lamp B (red)
REFRESH (discharge)
Lamp B (orange)