Canon Elura Elura Instruction Manual page 35

Notes:
• If your wireless controller isn't working, make sure the camera and the wireless
controller are both set to the same mode. Check the mode the camera is set to
by pushing any button other than the REMOTE SET button on the wireless
controller. The camera's mode appears in purple for about four seconds. Set the
wireless controller's mode accordingly by pressing the aforementioned button
combinations. If the wireless controller still doesn't work, change the batteries.
• The mode the camera is set to also appears for four seconds when you turn the
power on.
Turning off the tally lamp
The tally lamp lets you know that the
camera is recording. However, its
flashing may be reflected into the lens
during close-up recording, or when
recording through glass.
You may therefore decide to turn it off.
(see p. 30)
1. Open the camera menu, and point the arrow at TALLY LAMP.
2. Select the OFF setting and close the menu.
• The tally lamp no longer flashes during recording, but it will still light up
when the camera receives a signal from the wireless controller.
TALLY LAMP••ON
E
35