Table of Contents
Advertisement
CPU
Installing the CPU
X
X
5. Lift the load lever and the load
plate all the way up as shown in
the photo.
6. Remove the protective cap
from the CPU socket. The
cap is used to protect the
CPU socket against dust and
harmful particles. Remove the
protective cap only when you
are about to install the CPU.
7-1.Insert the CPU into the socket.
The gold triangular mark on the
CPU must align with the cham-
fer corner of the CPU socket
shown in the photo.
Important:
The CPU will fit in only one orientation and can easily be seated without exerting
any force.
User's Manual | CS620-H310
Load lever
Load
plate
Protective cap
Golden triangular
mark
CPU
Installing the CPU
X
X
7-2. Two keys on the socket
and notches on the CPU
Alignment key
also facilitate alignment.
7-3.The CPU's notch will fit into
the socket's alignment key
when it's seated in the cor-
Alignment key
rect orientation.
8. Close the load plate then
push the load lever down.
While closing the load plate,
make sure the front edge of
the load plate slides under
the retention knob.
9. Press down the load lever
and hook it under the reten-
tion tab.
Chapter 2
HARDWARE INSTALLATION
Load lever
Retention knob
12
Advertisement
Table of Contents
