Remote Control; Before You Start; Positioning; Wall-Mounting (Figure C) - Silvercrest SSB 70 C3 Operating Instructions And Safety Instructions

SSB 70 C3

7.1 Remote control

You can use the remote control supplied to control the sound bar functions. Please see the chart below for the button functions.
12 Mute
13
HDMI (ARC) Switch to HDMI ARC input
14
OPTICAL Switch to optical digital input SPDIF
15 Switch to Bluetooth
16 Play / Pause
17 Next track
18 STOP
19
TREBLE+ Amplify treble
20
BASS+ Increase bass
21 MOVIE Enables the equalizer for movies
22 3D Enables the equalizer with simulated surround sound
23 Battery compartment (on the back)
24
DIALOG Enables the equalizer for voice playback
25
MUSIC Enables the equalizer for music
26 BASS- Reduce bass
27
TREBLE- Attenuate treble
28 Repeat
29
VOL- Reduce volume
30 Previous title
31 VOL+ Increase volume
32 Toggle display on/off
33
USB Switch to USB input
34
AUX Switch to AUX input
35 On/Standby

8. Before you start

Remove the sound bar and all accessories from the package and remove the plastic films. Verify that you have received all items listed.

8.1 Positioning

The ideal position for your sound bar is centrally under your TV set. You can place the sound bar on a piece of furniture or mount it to the wall.

8.1.1 Wall-mounting (Figure C)

Make sure that you use suitable wall-mounting material.
Tools/mounting material needed (not included in the package):
•
Drill (depending on the wall)
•
2 screws and possibly 2 rawlplugs (depending on the wall) to fix to the wall. Please note that the screws must be suitable for the weight of the sound bar. If
the screws and rawlplugs provided are not suitable for your specific circumstances, make sure that the dimensions of the screw head and shaft correspond to
those provided in order to guarantee safe mounting.
•
Phillips screwdriver and possibly other screwdrivers, spirit level, pencil
Before drilling, make sure there are no water or gas pipes or electricity cables in the wall. If necessary, get an expert to mount the device on the wall.
•
Drill two holes 739 mm apart. Use the drilling template supplied to make mounting easier.
•
If you are using the rawlplugs supplied, use an 8 mm drill bit.
•
Insert the rawlplugs into the drilled holes.
•
Push the screws in until the screw head projects by about 3 mm.
•
Connect all the cables you are using to the connections on the sound bar.
•
Position the device with the wall mounting holes down onto the screws so that they engage with the vertical holders on the wall mounting system, then secure
by tightening the screws.
•
Finally, check that the sound bar is firmly fitted to both screws. If necessary, repeat the process. It may be necessary to rotate the screws clockwise or
counterclockwise a little.
20 - English
®