Installation - Husqvarna AUTOMOWER 105 Operator's Manual

Hide thumbs Also See for AUTOMOWER 105:
Table of Contents

Advertisement

Available languages

Available languages

33.1 Connecting the power supply
Take the following into consideration when planning
where to place the power supply:
Close to the charging station
Protection from rain
Protection from direct sunlight
WARNING:
used with a power supply unit supplied by
Husqvarna.
When connecting the power supply, only use a wall
socket that is connected to an earth fault-breaker (RCD)
with a tripping current of maximum 30 mA.
WARNING:
Install only to an earth-fault breaker (RCD)
with a tripping current of maximum 30 mA
when connecting the power supply to the
wall socket. For USA/CANADA: Use a
covered Class A GFCI receptacle (RCD)
that has an enclosure that is weatherproof
with the attachment plug cap inserted or
removed.
WARNING:
supply must be changed or tampered with.
The low voltage cable must not be
shortened or extended.
Low-voltage cables of different lengths are available as
accessories.
WARNING:
and extension cable must be outside the
work area to avoid damage to the cables.
WARNING:
circumstances mount the power supply at a
height where there is a risk it can be
submerged in water (at minimum 30 cm /
12" from the ground). It is not permitted to
place the power supply on the ground.

100 - Installation

33 Installation
The product is only to be
Risk of Electric Shock.
No parts of the power
The power supply cable
Do not under any
min 30 cm / 12"
WARNING:
the charging station, for instance before
cleaning the charging station or repairing the
loop wire.
WARNING:
and adjust the cutting height so that the
blades on the blade disc can never come in
contact with the cable.
WARNING:
damage to electrical components,
disconnect all connections to the charging
station (power supply, boundary wire and
guide wires) if there is a risk of a
thunderstorm.
WARNING:
power supply. Condensed water can harm
the power supply and increase the risk of
electrical shock.
For more instructions on how to do a proper installation,
Installation in the complete Operator's
refer to chapter
manual on Husqvarna's website www.husqvarna.com.
33.2 Control panel
All commands and settings for the product are made via
the control panel. All functions are accessed via a
number of menus.
The control panel consists of a display and a keypad. All
information is shown on the display and all input is done
using the buttons.
Note:
The display texts are shown in English in the
manual, but you will see the texts on the product display
in the chosen language.
Use the plug to disconnect
Place the low voltage cable
To reduce the risk of
Do not encapsulate the
1418 - 008 - 22.12.2020

Advertisement

Table of Contents
loading

Table of Contents