Help - Motorola MBP846CONNECT User Manual

Display
Registration

8. Help

No display
• Try recharging or replacing the battery pack.
• Reset the Units. Disconnect the battery pack of the Parent Unit and unplug
both the Units' electrical power, then plug them back in.
• Is the Unit turned on?
Press and hold the ON/OFF button
• Is the correct camera selected? Change the camera number, if necessary.
Interference
• Is the video display turned on? Press the VIDEO ON/OFF button
turn it ON.
• When operating using batteries only, the display will go blank after 5 minutes
or 30 minutes or 60 minutes to save power (depending on video settings).
The Unit is still active and will give you audio alerts. You can reactivate the
screen by pressing any button.
If the Baby Unit has lost its link with the Parent Unit
• Try recharging or replacing the battery pack.
• If the Baby Unit is too far away it may be going out of range, so move the
Baby Unit closer to the Parent Unit.
• Reset the Units by disconnecting them from the battery and electrical power.
Wait about 15 seconds before reconnecting. Allow up to one minute for the
Baby Unit and the Parent Unit to synchronise.
• See 4.8 Pair and Replace a Baby Unit, if there is a need to re-register the Units.
Noise interference on your Parent Unit
• Your Baby and Parent Units may be too close. Move them further apart.
• Make sure there is at least 3 to 6ft (1 to 2m) between the 2 Units to avoid
audio feedback.
• lf the Baby Unit is too far away, it may be out of range. Move the Baby Unit
closer to the Parent Unit.
38
on the Parent Unit to turn it ON.
to
Help