For Mac - Cables to Go ZRC0104C User Manual

Step 4. To obtain new IP settings from WPD –140, run "ipconfig / renew." As listed below, the
IP address is your client computer's LAN IP address, and the Default Gateway is
ZSR0104C SERIES IP address. Make sure that your IP Address is 192.168.1.xxx (xxx
ranges from 2 to 254), your Subnet Mask is 255.255.255.0, and your Default Gateway is
192.168.1.1. These values confirm that your ZSR0104C SERIES is functioning. (Figure
A-44)

4. For Mac

The instructions are based on Mac OS 8.5. It is similar to Mac OS 7.x and above. Follow the steps
to verify IP settings.
Step 1. Pull down the Apple Menu. Go through "Control Panel→TCP/IP."
Step 2. The new IP settings will be displayed in the TCP/IP window. Make sure that your IP
address is 192.168.1.xxx (xxx ranges from 2 to 254), your Subnet Mask is 255.255.255.0,
and your Default gateway is 192.168.1.1. These values confirm that your ZSR0104C
SERIES is functioning. The IP address is your LAN client's IP address, and the Default
Gateway is ZSR0104C SERIES IP address.
Figure A-44
Page 49